I ran by Sears to see if they had they EVA foam mat that I saw on some other builds but they only had it on special order. While I was finishing up the leg pieces, I decided to order my foam. The thigh is good, but I’ll have to scale the shin down to 110%. When connected to the thigh, it comes down a bit too far on my foot and would overlap the boot too far. It fits great, but the shin is a bit long. This piece will probably have to be pretty precise since it’ll link the boot with the thigh, with not much room for error. I slid this on and had enough room for it to go over my jeans, which is good because when I transfer this to foam, it’ll be a bit thicker. This is the side view of the shin piece at 115%. These are all the pieces that go into one shin piece, so as you can see, things are going to slow down a bit going forward. The leg pieces have about twice the pieces, and most of which are a lot smaller, which means a lot more tape, and a lot more time. Compared to the leg pieces, the arm pieces are a cakewalk. With the arm pretty much finished, I’m starting to keep a log of the parts I’ve got finished, and the ones I need to reprint and rescale.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |